2010 Chrysler Town & Country Owner Manual - Page 483

482 MAINTAINING YOUR VEHICLE 1. From behind the bumper fascia, or the access panel on the air dam, twist the bulb counterclockwise, and remove 1. Raise the hood to access the rear of the headlamp bulb. housing. Front Side Marker Lamp NOTE: Access is somewhat limited. You may have to remove the inner fender well or remove the headlamp housing for bulb replacement. 2. Twist the socket and remove from the headlamp housing, then pull the bulb out. CAUTION! Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with an oily surface, clean the bulb with rubbing alcohol. 3. Push the new bulb into the socket and reinstall the 2. Disconnect wire harness from the bulb. socket by twisting until locked into the headlamp housing. 3. Reconnect the wiring harness to the new bulb and reinstall the bulb by twisting clockwise. Fog Lamp Rear Tail, Stop, Turn Signal, Side Marker and NOTE: Access to the fog lamp bulb is from the rear of Backup Lamp the fascia. On the left rear side of the fascia, remove the push pin and lower the hinged access door on the air 1. Raise the liftgate. dam.