2010 Dodge Charger Owner Manual - Page 29
2010 Dodge Charger Manual
Page 29 highlights
28 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE NOTE: • The park lamps will turn on and remain on during Remote Start mode. To Exit Remote Start Mode and Drive the Vehicle Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock • For security, power window and power sunroof op- the doors and disarm the Vehicle Security Alarm (if eration (if equipped) are disabled when the vehicle is equipped). Then, prior to the end of the 15-minute cycle, insert the Key Fob into the ignition switch and turn the in the Remote Start mode. switch to the RUN position. • The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, NOTE: the ignition switch must be cycled to the RUN position • The ignition switch must be in the RUN position in order to drive the vehicle. before you can repeat the start sequence for a third cycle. • For vehicles equipped with the Electronic Vehicle To Exit Remote Start Mode without Driving the Information Center (EVIC), the message "Insert Key/ Vehicle Turn To Run" will flash in the EVIC until you insert Press and release the REMOTE START button one time, the Key Fob. Once inserted, the message "Turn To or allow the engine to run for the entire 15-minute cycle. Run" will flash in the EVIC until you turn the Key Fob NOTE: To avoid unintentional shut downs, the system to run. will disable the one time press of the REMOTE START button for two seconds after receiving a valid Remote Start request.