2010 Dodge Charger Owner Manual - Page 49

48 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE As a guide, if you are shorter than average you will prefer a lower position, and if you are taller than average you will prefer a higher position. When you release the anchorage try to move it up and down to make sure that it is locked in position. 3. Slide the latch plate upward over the folded webbing. The folded webbing must enter the slot at the top of the latch plate. 4. Continue to slide the latch plate up until it clears the folded webbing. In the rear seat, move toward the center of the seat to Automatic Locking Retractors (ALR) Mode - If position the belt away from your neck. Equipped Lap/Shoulder Belt Untwisting Procedure In this mode, the shoulder belt is automatically preUse the following procedure to untwist a twisted lap/ locked. The belt will still retract to remove any slack in shoulder belt. the shoulder belt. The Automatic Locking Mode is available on all passenger-seating positions with a combina1. Position the latch plate as close as possible to the tion lap/shoulder belt. anchor point. When To Use The Automatic Locking Mode 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, Use the Automatic Locking Mode anytime a child safety grasp and twist the belt webbing 180 degrees to create a seat is installed in a seating position that has a belt with fold that begins immediately above the latch plate. this feature. Children 12 years old and under should always be properly restrained in the rear seat.