2010 Dodge Charger Owner Manual SRT8 - Page 329
2010 Dodge Charger Manual
Page 329 highlights
328 WHAT TO DO IN EMERGENCIES 2. Connect the Power Plug (8) to a different 12 Volt Pressure Gauge (3) will decrease quickly from approxipower outlet in your vehicle or another vehicle, if avail- mately 70 psi (5 Bar) to the actual tire pressure when the able. Make sure the engine is running before turning ON Sealant Bottle (1) is empty. the TIREFIT kit. 2. The pump will start to inject air into the tire immedi3. The Sealant Bottle (1) may be empty due to previous ately after the Sealant Bottle (1) is empty. Continue to use. Call for assistance. operate pump and inflate the tire to the pressure indicated on the tire pressure label on the driver-side latch NOTE: If the Mode Select Knob (5) is on air mode and pillar (recommended pressure). Check the tire pressure pump is operating, air will dispense from the Air Pump by looking at the Pressure Gauge (3). Hose (7) only, not the Sealant Hose (6). If the tire does not inflate to at least 26 psi (1.8 Bar) If the sealant (white fluid) does flow through the pressure within 15 minutes: Sealant Hose (6): • The tire is too badly damaged. Do not attempt to drive 1. Continue to operate pump until sealant is no longer the vehicle further. Call for assistance. flowing through hose (typically takes 30 - 70 seconds). As the sealant flows through the Sealant Hose (6), the NOTE: If the air pump is equipped with a Deflation Pressure Gauge (3) can read as high as 70 psi (5 Bar). The Button and the tire becomes over-inflated, press the Deflation Button to reduce the tire pressure to the recommended inflation pressure before continuing.