2010 Dodge Charger Owner Manual SRT8 - Page 331

330 WHAT TO DO IN EMERGENCIES WARNING! TIREFIT is not a permanent flat tire repair. Have the tire inspected and repaired or replaced after using TIREFIT. Do not exceed 55 mph (88 km/h) until having the tire repaired or replaced. Failure to follow this warning can result in injuries that are serious or fatal to you, your passengers, and others around you. If tire pressure is less than 19 psi (1.3 Bar) , the tire is too badly damaged. Do not attempt to drive the vehicle further. Call for assistance. If the tire pressure is 19 psi (1.3 bar) or higher: 1. Press the Power Button (4) to on and inflate the tire to the pressure indicated on the tire and loading information label on the driver-side door opening. NOTE: If the air pump is equipped with a Deflation Button and the tire becomes over-inflated, press the (E) After Securing TIREFIT Sealant in the Tire: Follow Step (A) "Whenever You Stop to Use TIREFIT" Deflation Button to reduce the tire pressure to the recommended inflation pressure before continuing. before continuing. 1. Turn the Mode Select Knob (5) to the Air Mode 2. Disconnect the TIREFIT kit from the valve stem and then reinstall the cap on the valve stem. position. 3. Place the TIREFIT kit in its proper storage area in the 2. Uncoil the Air Pump Hose (7) and connect it to the vehicle. valve stem. 4. Have the tire inspected and repaired or replaced at the 3. Check the pressure in the tire by reading the Pressure earliest opportunity at an authorized dealer or tire serGauge (3). vice center.