2011 Dodge Challenger Owner Manual SRT8 - Page 53

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 51 additional information, refer to "Installing Child ReLap/Shoulder Belt Untwisting Procedure Use the following procedure to untwist a twisted lap/ straints Using The Vehicle Seat Belt" under the "Child Restraints" section. The chart below defines the type of shoulder belt. feature for each seating position. 1. Position the latch plate as close as possible to the Driver Center Passenger anchor point. First Row N/A N/A ALR 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, Second Row ALR ALR ALR grasp and twist the belt webbing 180 degrees to create a Third Row N/A N/A N/A fold that begins immediately above the latch plate. • N/A - Not Applicable 3. Slide the latch plate upward over the folded webbing. The folded webbing must enter the slot at the top of the • ALR - Automatic Locking Retractor latch plate. If the passenger seating position is equipped with an 4. Continue to slide the latch plate up until it clears the ALR and is being used for normal usage: folded webbing. Only pull the belt webbing out far enough to comfortably Seat Belts In Passenger Seating Positions wrap around the occupant's mid-section so as to not The seat belts in the passenger seating positions are activate the ALR. If the ALR is activated, you will hear a equipped with Automatic Locking Retractors (ALR) ratcheting sound as the belt retracts. Allow the webbing which are used to secure a child restraint system. For to retract completely in this case and then carefully pull 2