2011 Dodge Dakota Extended Cab Owner Manual - Page 158
2011 Dodge Dakota Extended Cab Manual
Page 158 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157 Your vehicle should be parked outside of the garage If the signal is too weak to train, replace the battery in the handheld transmitter. while training. • Turn the ignition switch to the ON/RUN position. NOTE: Some gate operators and garage door openers may require you to replace Step 3 with procedures noted • Place the handheld transmitter 1 to 3 inches (3 to 8 cm) in the "Gate Operator/Canadian Programming" section. from the HomeLink buttons while keeping the • Press and hold the just-trained HomeLink button. If HomeLink display in view. the indicator(s) blink rapidly for two seconds and then For optimal training, point the battery end of the remains constant, continue with the next section: "Prohandheld transmitter away from the HomeLink. gramming A Rolling Code System". • Simultaneously, press and hold both the chosen NOTE: After training a HomeLink channel, if the HomeLinkbutton and the handheld transmitter butgarage door does not operate with HomeLink and the ton until the indicator(s) change from a slow to a rapid garage door opener was manufactured after 1995, the flash rate. garage door opener may have rolling code. If so, proceed Then release both the HomeLink and handheld trans- to the heading, "Programming A Rolling Code System." mitter buttons. Programming A Rolling Code System It may take up to 30 seconds or longer in rare cases. The At the garage door opener motor (in the garage), locate the "Learn" or "Training" button. garage door may open and close while you train. 3