2011 Dodge Dakota Extended Cab Owner Manual - Page 19

18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 3. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch to the LOCK position and remove the second key. Repeat this procedure to program up to eight keys. If you do not have a programmed Sentry Key௡, contact your authorized dealer for details. NOTE: If a programmed key is lost, see your authorized dealer to have all remaining keys erased from the system's memory. This will prevent the lost key from starting your vehicle. The remaining keys must then be reprogrammed. All vehicle keys must be taken to an authorized dealer at the time of service to be reprogrammed. 4. Insert a blank Sentry Key௡ into the ignition switch. Turn the ignition switch to the ON/RUN position within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing. To indicate that programming is complete, the Vehicle Security Light will turn on again for three seconds and VEHICLE SECURITY ALARM - IF EQUIPPED The Vehicle Security Alarm monitors the vehicle doors then turn off. and ignition for unauthorized operation. When the VeThe new Sentry Key௡ is programmed. The Remote hicle Security Alarm is activated it will provide both Keyless Entry (RKE) transmitter will also be pro- audible and visible signals. The horn will sound repeatgrammed during this procedure. edly for the three minutes and the headlights, park lamps and/or turn signals and Vehicle Security Light will flash for an additional 15 minutes.