2011 Dodge Ram 1500 Crew Cab User Guide - Page 35

ELECTRONICS NOTE: Your radio may not be equipped with Voice Command or Uconnect™ Phone. To determine if your radio has this feature, press the Voice Command button on the radio. You will hear a voice prompt if you have the feature, or see a message on the radio stating "Uconnect Phone not available" if you do not. • Your radio has many features that add to the comfort and convenience of you and your passengers. Some of these radio features should not be used when driving because they take your eyes from the road or your attention from driving. • The radio sales code is located on the lower right side of the radio faceplate. Seek Up/Down Buttons • Press to seek through radio stations in AM, FM, or SAT bands. Seek through tracks in CD mode. • Hold either button to bypass stations without stopping. Audio Settings • Press the TUNE/SCROLL control knob and BASS, MID, TREBLE, BALANCE and FADE will display. Rotate the TUNE/SCROLL control knob to select the desired setting. Audio Jack • The Audio Jack allows a portable device, such as an MP3 player or a cassette player, to be plugged into the radio and utilize the vehicle's audio system, using a 3.5 mm audio cable, to amplify the source and play through the vehicle speakers. • Pressing the AUX button will change the mode to auxiliary device if the Audio Jack is connected, allowing the music from your portable device to be heard through the vehicle's speakers. • The functions of the portable device are controlled using the device buttons. The volume may be controlled using the radio or portable device. Clock Setting • Press and hold the TIME button until the hours blink; turn the TUNE/SCROLL control knob to set the hours. • Press the TUNE/SCROLL control knob until the minutes begin to blink; turn the TUNE/SCROLL control knob to set the minutes. • Press the TUNE/SCROLL control knob to save the time change. • To exit, press any button/knob or wait five seconds. Store Radio Presets • Press the SET/RND button once and SET 1 will show in the display. Then select the button (1-6). • A second station may be added to each push button. Press the SET/RND button twice and SET 2 will show in the display, then select button (1-6). 33