2011 Dodge Ram 1500 Crew Cab User Guide - Page 61

UTILITY Extender Position • The bed extender will add an additional 15 in (38 cm) in the back of the truck when additional cargo room is needed. • To install the bed extender into the extender position, perform the following: • Lower the tailgate. • Make sure the center handle is unlocked and rotate the center handle vertically in order to release the extender side gates. • Fit the end of the side gate ends onto the pin and handle. • Rotate the handles to the horizontal position to secure into place. CAUTION! • Failure to follow the following items could cause damage to the vehicle: • Assure that all cargo inside the storage bins is properly secured. • Do not exceed cargo weight rating of 150 lb (68 kg) per bin. • Leaving the lid open for extended periods of time could cause the vehicle battery to discharge. If the lid is required to stay open for extended periods of time, it is recommended that the bin lights be turned off manually using the on/off switch. • Ensure cargo bin lids are closed and latched before moving or driving vehicle. • Loads applied to the top of the bin lid should be minimized to prevent damage to the lid and latching/hinging mechanisms. • Damage to the RamBox® bin may occur due to heavy/sharp objects placed in bin that shift due to vehicle motion. In order to minimize potential for damage, secure all cargo to prevent movement and protect inside surfaces of bin from heavy/sharp objects with appropriate padding. • The maximum load per cleat should not exceed 250 lbs (113 kg) and the angle of the load on each cleat should not exceed 60 degrees above horizontal, or damage to the cleat or cleat rail may occur. Bed Rail Tie-Down System • There are two adjustable cleats on each side of the bed that can be used to assist in securing cargo. • Each cleat must be located and tightened down in one of the detents, along either rail, in order to keep cargo properly secure. • To move the cleat to any position on the rail, turn the nut counterclockwise, approximately three turns. Then, pull out on the cleat and slide it to the detent nearest the desired location. Make sure the cleat is seated in the detent and tighten the nut. • To remove the cleats from the utility rail, remove the end cap by pushing up on the locking tab, located on the bottom of the end cap. Slide the cleat off the end of the rail. 59