2014 Dodge Dart Owner Manual - Page 258

256 UNDERSTANDING THE FEATURES OF YOUR VEHICLE ParkSense® will retain the last system state (enabled or ParkSense® Warning Display disabled) from the last ignition cycle when the ignition is The ParkSense® Warning screen will only be displayed if changed to the ON/RUN position. Sound and Display is selected from the Uconnect® ParkSense® can be active only when the shift lever is in System. Refer to "Uconnect® Settings" in "UnderstandREVERSE. If ParkSense® is enabled at this shift lever ing Your Instrument Panel" for further information. position, the system will remain active until the vehicle The ParkSense® Warning screen is located within the speed is increased to approximately 11 mph (18 km/h) or Electronic Vehicle Information Center (EVIC). It provides above. The system will become active again if the vehicle visual warnings to indicate the distance between the rear speed is decreased to speeds less than approximately fascia/bumper and the detected obstacle. Refer to "Elec10 mph (16 km/h). tronic Vehicle Information Center (EVIC)/Settings" in ParkSense® Sensors The four ParkSense® sensors, located in the rear fascia/ bumper, monitor the area behind the vehicle that is ParkSense® Display within the sensors' field of view. The sensors can detect When the vehicle is in REVERSE, the warning display obstacles from approximately 12 in (30 cm) up to 59 in will turn ON indicating the system status. (150 cm) from the rear fascia/bumper in the horizontal direction, depending on the location, type and orientation of the obstacle. "Understanding Your Instrument Panel" for further information.