2014 Dodge Dart Owner Manual - Page 33

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 31 • For security, power window and power sunroof To Exit Remote Start Mode And Drive The Vehicle operation (if equipped) are disabled when the vehicle Before the end of 15-minute cycle, press and release the is in the Remote Start mode. UNLOCK button on the RKE transmitter to unlock the • The engine can be started two consecutive times (two doors and disarm the Vehicle Security Alarm (if 15-minute cycles) with the RKE transmitter. However, equipped). Then, prior to the end of the 15-minute cycle, the ignition must be cycled to the RUN position before press and release the START/STOP button (vehicles equipped with Keyless Enter-N-Go™) or insert the key you can repeat the start sequence for a third cycle. and turn it to the RUN position (vehicles not equipped To Exit Remote Start Mode Without Driving The with Keyless Enter-N-Go™). Vehicle NOTE: The message ЉRemote Start Active Push Start Press and release the REMOTE START button one time or ButtonЉ (vehicles equipped with Keyless Enter-N-Go™) allow the engine to run for the entire 15-minute cycle. or ЉRemote Start Active Key to RunЉ (vehicles not NOTE: To avoid unintentional shutdowns, the system equipped with Keyless Enter-N-Go™) will display in the will disable the one time press of the REMOTE START EVIC until you push the START button or turn the key to button for two seconds after receiving a valid Remote the RUN position. Start request. 2