1996 Ford Escort Owner's Manual - Page 194

To rewind the shade: 1. Remove the shade from its side mounting brackets and take it out of your vehicle. To remove it from your vehicle, detach the tethered mounting screws from the trim panels and push one end of the tension rod toward the opposite side of the vehicle until the shade can be removed from the mounting clips. 2. Extend the shade fully. Make sure the smooth grain side is facing you (see Figure 1). Wrap the vinyl around the roller tube two times in the direction shown in Figure 1. Tuck the edges of the vinyl inside the end cap with each wrap. Fold the edges of the vinyl toward the center. Make sure the edges of the vinyl clear the end cap slots (see Figure 2). Use masking tape or a rubber band to hold the vinyl on the left side of the roller tube. While holding the vinyl and roller tube as shown in Figure 2, push the right end cap (marked with an "R") about 1/4 inch to disengage the clutch. Wind the shade 14 revolutions in the direction shown in Figure 2. (The wind direction is also marked on the end cap.) 3. 4. 5. 6. 7. 194