2014 Ford Fusion Energi Owner Manual Printing 1 - Page 167

High Voltage Battery When Value Charge has been selected charging may not begin upon plugging in. The vehicle may delay charging to take advantage of off-peak electricity rates. The vehicle will optimize the charge schedule to be complete by the next GO Time. When waiting to charge (not actively charging), the light ring will indicate the present state of charge of the high voltage battery as follows: • When the top right quadrant is shut off the charge is between 0-25 percent. • When the top right quadrant is solidly lit and the bottom right quadrant is shut off the charge is between 25-50 percent. • When both right side quadrants are solidly lit and the bottom left quadrant is shut off the charge is between 50-75 percent. • When three quadrants are solidly lit and the top left quadrant is shut off the charge is between 75-100 percent. • When the entire ring is solidly lit, the charge is 100 percent. Note: When the vehicle is Waiting to Charge the light ring will shut off one minute after displaying the present state of charge. When the vehicle automatically begins charging the light ring will turn on and display how far along the charge is per the section above. Note: If a vehicle charging system fault is detected at any point in a charge cycle the entire light ring will flash continuously for one minute and then shut off. If this happens unplug, and then re-plug the charging coupler into the charge port receptacle. If the problem persists contact your authorized dealer. The light ring illumination conditions can be modified. See Charge Port Light Ring Settings in the MyFord Touch section. See MyFord Touch™ (page 356). Disconnecting the Charging Coupler Note: Do not pull the wall plug from the wall while the vehicle is charging. Doing so may damage the outlet and the cord. 1. Press the button on the charging coupler. 2. While holding the button, remove the charging coupler from the vehicle's charge port receptacle. E144781 3. Close the charge port door by pressing the indentation on the charge port door. Continue pressing the indentation while the door rotates counter clockwise and closes. HIGH VOLTAGE BATTERY CUTOFF SWITCH The high-voltage shut off operation shuts off power from the high-voltage battery after a collision, or if your vehicle receives a substantial physical jolt. To reactivate the vehicle after either event perform the following steps: 1. Turn the ignition off. 2. Turn the ignition on. 3. If the vehicle is not powered after this sequence, repeat steps 1 and 2. For vehicles equipped with a push button start system: 164