2014 Ford Fusion Energi Owner Manual Printing 1 - Page 26
2014 Ford Fusion Energi Manual
Page 26 highlights
Child Safety E144275 E142537 Perform the following steps to install a child safety seat with tether anchors: Note: If you install a child seat with rigid LATCH attachments, do not tighten the tether strap enough to lift the child seat off your vehicle seat cushion when the child is seated in it. Keep the tether strap just snug without lifting the front of the child seat. Keeping the child seat just touching your vehicle seat gives the best protection in a severe crash. 1. Route the child safety seat tether strap over the back of the seat. For outboard seating positions, route the tether strap under the head restraint and between the head restraint posts. For the center seating positions, route the tether strap over the top of the head restraint. If needed, the head restraints can also be removed. 3. Clip the tether strap to the anchor as shown. 4. Tighten the child safety seat tether strap according to the manufacturer's instructions. If your child restraint system is equipped with a tether strap, and the child restraint manufacturer recommends its use, Ford also recommends its use. CHILD SAFETY LOCKS When these locks are set, the rear doors cannot be opened from the inside. E144274 E112197 2. Locate the correct anchor for the selected seating position, then open the tether anchor cover. The childproof locks are located on the rear edge of each rear door and must be set separately for each door. 23