2014 Ford Fusion Energi Owner Manual Printing 1 - Page 65

Security You must have two previously programmed coded keys and the new unprogrammed key readily accessible. See an authorized dealer to have the spare key programmed if two previously programmed coded keys are not available. Read and understand the entire procedure before you begin. 1. 2. Insert the first previously programmed coded key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds. Switch the ignition off and remove the first coded key from the ignition. After three seconds but within 10 seconds of switching the ignition off, insert the second previously coded key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds. Switch the ignition off and remove the second previously programmed coded key from the ignition. After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed coded key, insert the new unprogrammed key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least six seconds. Remove the newly programmed coded key from the ignition. Programming a Spare Intelligent Access Key Note: You can program a maximum for four intelligent access keys to your vehicle. You must have two previously programmed intelligent access keys inside your vehicle and the new unprogrammed intelligent access keys readily accessible. See an authorized dealer to have the spare key programmed if two previously programmed keys are not available. Make sure that your vehicle is off before beginning this procedure. Make sure that you close all the doors before beginning and that they remain closed throughout the procedure. Perform all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you perform any steps out of sequence. Read and understand the entire procedure before you begin. 3. 4. 5. 6. 7. 8. 9. E147165 1. If the key has been successfully programmed it will start your vehicle and operate the remote entry system (if the new key is an integrated keyhead transmitter). If programming was not successful, wait 10 seconds and repeat Steps 1 through 8. If you are still unsuccessful, take your vehicle to an authorized dealer. Place a programmed intelligent access key in the backup slot in the center console. The key ring must be at the top with the buttons facing toward the rear. 2. Wait 5 seconds, and then press the START/STOP button. 3. Remove the intelligent access key. 62