2014 Ford Transit Connect Cargo Owner Manual Printing 1 - Page 112
2014 Ford Transit Connect Cargo Manual
Page 112 highlights
Starting and Stopping the Engine STARTING A GASOLINE ENGINE Before starting the engine check the following: Make sure all occupants have fastened their safety belts. Make sure the headlamps and electrical accessories are off. Make sure the parking brake is on. Move the transmission selector lever to position park (P). The idle speed will vary depending on certain factors. These include vehicle component and ambient temperatures as well as electrical and climate system demands. Cold or Hot Engine If the engine does not start within 10 seconds, wait for a short period and try again. If the engine does not start after three attempts, wait 10 seconds and follow the flooded engine procedure. If you have difficulty starting the engine when the temperature is below -13°F (-25°C), press the accelerator pedal to the mid-way point of its travel and try again. When you start the engine, the idle speed increases, this helps to warm up the engine. If the engine idle speed does not slow down automatically, have your vehicle checked by an authorized dealer. Note: You can only operate the starter for a limited period of time, for example 10 seconds. The number of start attempts is limited to approximately six. If you exceed this limit, the system will not allow you to try again until a period of time has elapsed, for example 30 minutes. 1. Fully press the brake pedal. 2. Turn the ignition key to position II to switch the ignition on. 3. Turn the ignition key to position III to start your vehicle. Release the key when the engine starts. Note: Do not touch the accelerator pedal. Flooded Engine Move the transmission selector lever to position P. 2. Fully depress the accelerator pedal and hold it there. 3. Start the engine. Note: If the engine does not start, repeat the cold or hot engine procedure. 1. SWITCHING OFF THE ENGINE Vehicles With a Turbocharger WARNING Do not switch the engine off when it is running at high speed. If you do, the turbocharger will continue running after the engine oil pressure has dropped to zero. This will lead to premature turbocharger bearing wear. Release the accelerator pedal. Wait until the engine has reached idle speed and then switch it off. Engine Idle Speed after Starting The speed at which the engine idles immediately after starting will adjust automatically to minimize vehicle emissions and maximize cabin comfort and fuel economy. 109 Tourneo Connect/Transit Connect (CHC) Canada/United States of America