2014 Ford Transit Connect Cargo Owner Manual Printing 1 - Page 230
2014 Ford Transit Connect Cargo Manual
Page 230 highlights
Wheels and Tires the procedure from step 2. If after repeated attempts to enter the reset mode, the horn does not chirp and the system indicator does not flash, have your vehicle checked by an authorized dealer as soon as possible. 5. Train the system sensors in the tires using the following reset sequence starting with the left front tire and following a clockwise order: Left front, right front, right rear, left rear. 6. Remove the valve cap from the valve stem on the left front tire. Decrease the air pressure until the horn chirps. Note: The single horn chirp confirms that the sensor identification code has been learned by your vehicle for this position. If a double horn chirp is heard, the reset procedure was unsuccessful and must be repeated. 7. Remove the valve cap from the valve stem on the right front tire. Decrease the air pressure until the horn chirps. 8. Remove the valve cap from the valve stem on the right rear tire. Decrease the air pressure until the horn chirps. 9. Remove the valve cap from the valve stem on the left rear tire. Decrease the air pressure until the horn chirps. Training is complete when the horn chirps after the last system sensor (left rear) has been trained and the system indicator stops flashing. 10. Switch the ignition off. If two short horn chirps are heard, the reset procedure was unsuccessful and must be repeated. Note: If after repeating the procedure two short horn chirps are heard again, have your vehicle checked by an authorized dealer as soon as possible. 11. Set all four tires to the correct pressure See Maintenance (page 176). or the tire inflation pressure label (located on the edge of driver door or the B-Pillar). CHANGING A ROAD WHEEL WARNINGS The use of tire sealants may damage your tire pressure monitoring system and should not be used. However, if you must use a sealant, the tire pressure monitoring system sensor and valve stem on the wheel must be replaced by an authorized Ford dealer. If the tire pressure monitor sensor becomes damaged, it will no longer function. See Tire Pressure Monitoring System (page 223). Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle. If you get a flat tire while driving, do not apply the brake heavily. Instead, gradually decrease your speed. Hold the steering wheel firmly and slowly move to a safe place on the side of the road. Have a flat serviced by an authorized dealer in order to prevent damage to the tire pressure monitoring system sensors. See Tire Pressure Monitoring System (page 223). Replace the spare tire with a road tire as soon as possible. During repairing or replacing of the flat tire, have an authorized dealer inspect the tire pressure monitoring system sensor for damage. 227 Tourneo Connect/Transit Connect (CHC) Canada/United States of America