2015 Ford Transit 150 Van Owner Manual Printing 3 - Page 34
2015 Ford Transit 150 Van Manual
Page 34 highlights
Safety Belts Switching the Belt-Minder on and off WARNING While the system allows you to switch it off, this system is designed to improve your chances of being safely belted and surviving a crash. We recommend you leave the system switched on. To reduce the risk of injury, do not switch the system on or off while driving your vehicle. Read Steps 1 - 4 thoroughly before proceeding with the programming procedure. The system can be switched on and off by carrying out the following procedure: Before following the procedure, make sure that: • The parking brake is set. • The transmission selector lever is in position park (P). • The ignition is switched off. • The driver safety belt is unbuckled. 1. Switch the ignition on. Do not start the engine. 2. Wait until the safety belt warning light turns off (about one minute). After Step 2, wait an additional five seconds before proceeding with Step 3. Once Step 3 is started, the procedure must be completed within 30 seconds. 3. Buckle then unbuckle the driver safety belt three times at a moderate speed, ending in the unbuckled state. After Step 3, the safety belt warning light will illuminate. 4. While the safety belt warning light is illuminated, buckle then unbuckle the driver safety belt. After Step 4, the safety belt warning light will flash for confirmation. • • This will disable the feature if it is currently enabled. This will enable the feature if it is currently disabled. CHILD RESTRAINT AND SAFETY BELT MAINTENANCE Inspect the vehicle safety belts and child safety seat systems periodically to make sure they work properly and are not damaged. Inspect the vehicle and child seat safety belts to make sure there are no nicks, tears or cuts. Replace if necessary. All vehicle safety belt assemblies, including retractors, buckles, front safety belt buckle assemblies, buckle support assemblies (slide bar-if equipped), shoulder belt height adjusters (if equipped), shoulder belt guide on seat back (if equipped), child safety seat LATCH and tether anchors, and attaching hardware, should be inspected after a crash. Read the child restraint manufacturer's instructions for additional inspection and maintenance information specific to the child restraint. Ford Motor Company recommends that all safety belt assemblies in use in vehicles involved in a crash be replaced. However, if the crash was minor and an authorized dealer finds that the belts do not show damage and continue to operate properly, they do not need to be replaced. Safety belt assemblies not in use during a crash should also be inspected and replaced if either damage or improper operation is noted. Properly care for safety belts. See Vehicle Care (page 227). 31 Transit (TTH) Canada/United States of America, enUSA, Edition date: 03/2014, Third Printing