2008 Honda S2000 Owner's Manual - Page 175
2008 Honda S2000 Manual
Page 175 highlights
Main Menu Table Of Contents Changing the Oil and Filter 5. Install a new oil filter according to the instructions that come with it. 6. Put a new washer on the drain bolt, then reinstall the drain bolt. Tighten the drain bolt to: 29 lbf·ft (39 N·m , 4.0 kgf·m) 7. Refill the engine with the recommended oil. WASHER OIL DRAIN BOLT OIL FILTER 2. Open the hood, and remove the engine oil fill cap. Remove the oil drain bolt and washer from the bottom of the engine. Drain the oil into an appropriate container. 3. Remove the oil filter, and let the remaining oil drain. A special wrench (available from your dealer) is required. 4. Make sure the oil filter gasket is not stuck to the engine block. If it is, remove it before installing a new oil filter. Engine oil change capacity (including filter): 5.1 US qt (4.8 ) 8. Install the engine oil fill cap. Start the engine. The oil pressure indicator should go out within 5 seconds. If it does not, turn off the engine, and check your work. 172 2008 S2000