2008 Honda S2000 Owner's Manual - Page 183

Main Menu Table Of Contents Lights CONNECTOR BULB 6. Insert the socket back into the headlight assembly. Make sure the bulb is installed correctly by looking through the headlight lens. The pins on the base of the bulb should fit in the holes in the headlight assembly. Pivot the holddown wire back in place, and clip the end into the slot. 7. Install the rubber seal over the back of the headlight assembly. 1. Open the hood. If you need to change the high beam headlight bulb on the driver's side, remove the coolant reserve tank from its holder by pulling it straight up. 2. Remove the electrical connector from the bulb by squeezing the connector to unlock the tab, then slide the connector off the bulb. 3. Remove the rubber weather seal by pulling on the tab. 4. Unclip the end of the hold-down wire from its slot. Pivot it out of the way, and remove the bulb socket. 5. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms. 8. Push the electrical connector onto the new bulb. Turn on the headlights to test the new bulb. 9. (Driver's side) Reinstall the coolant reserve tank. 180 2008 S2000