2010 Honda Fit Owner's Manual - Page 269
2010 Honda Fit Manual
Page 269 highlights
Lights 4. Unclip the end of the hold-down wire from its slot. Pivot the wire out of the way, then remove the bulb. 5. Install the new bulb into the hole, making sure the tabs are in their slots. Pivot the hold-down wire back in place, and clip the end into the slot. INSPECTION WINDOW HOLD-DOWN WIRE Replacing a Parking Light/Front Side Marker Bulb 6. Make sure that the hold-down wire is installed properly and securely. You can check its installation from the inspection window on the headlight assembly. 7. Install the rubber seal over the back of the headlight assembly. 8. Push the electrical connector onto the new bulb. Make sure it is connected securely. Turn on the headlights to test the new bulb. Maintenance 1. Open the hood. 2. Remove the socket by turning it one-quarter turn counterclockwise. 3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms. 4. Reinstall the socket into the light assembly by turning it clockwise until it locks. CONTINUED 263