2008 Infiniti EX35 Owner's Manual - Page 119
2008 Infiniti EX35 Manual
Page 119 highlights
WELCOME LIGHT switch and release it; it need not be held. The roof will automatically open or close all the way. To stop the roof, push the switch once more while it is opening or closing. Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs. Auto reverse function WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof. If the control unit detects something caught in the moonroof when it is closing, the moonroof will be immediately opened. The auto reverse function can be activated when the moonroof is closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is pushed to the OFF position. If the moonroof cannot be closed automatically when the auto reverse function activates due to a malfunction, push and hold the CLOSE 1 side of the moonroof switch. If the moonroof does not operate If the moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system. 1. If the moonroof is open, close it fully by repeatedly pushing the CLOSE 1 side of the moonroof switch. 2. Push and hold the CLOSE 1 side of the moonroof switch to tilt the moonroof up. 3. Release the moonroof switch after the moonroof moves slightly up and down. 4. Push and hold the OPEN 2 side of the moonroof switch to fully tilt the moonroof down. 5. Check if the moonroof switch operates normally. If the moonroof does not operate properly after performing the procedure above, have your vehicle checked by an INFINITI dealer. SIC3642 To activate or deactivate the welcome light function, perform the following procedure. Note that the function is set to disabled as the factory default setting. 1. Push the ignition switch to the ON position. 2. Open the driver's side door. 3. Push the door open request switch on the driver's side door handle for more than 5 seconds with the driver's door open. 4. A chime sounds when the setting is completed. Instruments and controls 2-51