2008 Infiniti EX35 Owner's Manual - Page 425
2008 Infiniti EX35 Manual
Page 425 highlights
INSTALLING FRONT LICENSE PLATE Use the following steps to mount the license plate. Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag. Only use the recommended mounting position or Intelligent Cruise Control (ICC) sensor obstruction (if so equipped) may result. ● License plate bracket ● J-nut × 2 ● Screw × 2 ● Screw grommet × 2 1. Park the vehicle on flat, level ground. 2. Place the license plate bracket with the positioner A fit to the bumper pillar B and the side end surface of the bracket aligned with the bumper C . 3. Mark the center of the hole D with a felt-tip pen. 4. Carefully drill two pilot holes using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the bumper fascia.) 5. Insert grommets into the hole on the fascia. 6. Insert a flat-blade screwdriver into the grommet hole to add 90° turn onto the part E . 7. Insert a J-nut into the license plate bracket before placing the license plate bracket on the fascia. 8. Install the license plate bracket with screws. 9. Install the license plate with bolts that are no longer than 0.55 in (14 mm). VEHICLE LOADING INFORMATION WARNING ● It is extremely dangerous to ride in a cargo area inside the vehicle. In a collision, people riding in these areas are more likely to be seriously injured or killed. ● Do not allow people to ride in any area of vehicle that is not equipped with seats and seat belts. ● Be sure everyone in your vehicle is in a seat and using a seat belt properly. TERMS It is important to familiarize yourself with the following terms before loading your vehicle: ● Curb Weight (actual weight of your vehicle) - vehicle weight including: standard and optional equipment, fluids, emergency tools, and spare tire assembly. This weight does not include passengers and cargo. Technical and consumer information 9-13