2009 Infiniti EX35 Owner's Manual - Page 126

4. Hold down both buttons until the indicator light on HomeLink flashes, changing from a "slow blink" to a "rapid blink". This could take up to 90 seconds. When the indicator light blinks rapidly, both buttons may be released. The rapidly flashing light indicates successful programming. To activate the garage door or other programmed device, push and hold the programmed HomeLink button - releasing when the device begins to activate. SIC3182 SIC3183 1. To begin, push and hold the 2 outer HomeLink buttons (to clear the memory) until the indicator light A blinks (after 20 seconds). Release both buttons. 2. Position the end of the hand-held transmitter 1-3 inches away from the HomeLink surface. 3. Using both hands, simultaneously push and hold both the HomeLink button you want to program and the hand-held transmitter button. DO NOT release the buttons until step 4 has been completed. 5. If the indicator light on HomeLink blinks rapidly for two seconds and then turns solid, HomeLink has picked up a "rolling code" garage door opener signal. You will need to proceed with the next steps to train HomeLink , completing the programming may require a ladder and another person for convenience. 6. Push and release the program button located on the garage door opener's motor to activate the "training mode". This button is usually located near the antenna wire that hangs down from the motor. If the wire originates from under a light lens, you will need to remove the lens to access the training button. 2-58 Instruments and controls