2009 Infiniti EX35 Owner's Manual - Page 155

● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) fully for at least 1 second. The driver's seat, steering column and outside mirrors will move to the memorized position or to the exit position when the entry/exit function is set to active with the indicator light flashing, and then the light will stay on for approximately 5 seconds. ● When the engine is started while moving the automatic drive positioner. ● When the AT selector lever is moved from the P (Park) position to any other position. (However, it will not be canceled if the switch is pushed while the seat and steering column are returning to the previous positions (entry/exit function).) ● When the driver's door remains open for more than 45 seconds and the ignition switch is not in the ON position. ● The seat synchronization function is automatically disabled if the outside mirrors or steering wheel reaches its maximum adjustment. ● The seat synchronization function will not move if the seat is adjusted over one of the following maximum thresholds: - Seat sliding: 3.0 in (76 mm) - Seatback reclining: 9.1 degrees - Seat lifter (rear side): 0.8 in (20 mm) SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: ● When the vehicle speed is above 4 MPH (7 km/h). ● When the adjusting switch for the driver's seat and steering column is turned on while the automatic drive positioner is operating. ● When the memory switch 1 or 2 is not pushed for at least 1 second. ● When the seat, steering column and outside mirrors have already been moved to the memorized position. ● When no position is stored in the memory switch. Pre-driving checks and adjustments 3-27