2009 Infiniti EX35 Owner's Manual - Page 154

The indicator lights on the memory switches (1 and 2) will blink once when the function is canceled, and the indicator lights will blink twice when the function is activated. 4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2) fully for at least 1 second. The indicator light for the pushed memory switch will stay on for approximately 5 seconds after pushing the switch. If memory is stored in the same memory switch, the previous memory will be deleted. Confirming memory storage ● Push the ignition switch to the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 second. When the memory has stored in position, the indicator light will stay on for approximately 5 seconds. ● If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. In this case, reset the desired position using the previous procedure. ● If optional Intelligent Keys are added to your vehicle, the memory storage procedure to switch 1 or 2 and linking Intelligent Key procedure to a stored memory position should be performed again for each Intelligent Key. For additional Intelligent Key information, see "KEYS" earlier in this section. MEMORY STORAGE Two positions for the driver's seat, steering column and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Move the selector lever to the P (Park) position. 2. Push the ignition switch to the ON position. 3. Adjust the driver's seat, steering column and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see "SEATS" in the "1. Safety - Seats, seat belts and supplemental restraint system" section and "TILT/TELESCOPIC STEERING" page 3-19 and "OUTSIDE MIRRORS" earlier in this section. Linking Intelligent Key to a stored memory position The Intelligent Key can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 secbutton on onds, push the UNLOCK the Intelligent Key. If the indicator light blinks, the Intelligent Key is linked to that memory setting. Push the ignition switch to the OFF position, button on the and then push the UNLOCK Intelligent Key. The driver's seat, steering wheel and outside mirrors will move to the memorized position or to the exit position when the entry/exit function is set to active. Selecting the memorized position 1. Move the selector lever to the P (Park) position. 2. Use one of the following methods to move the driver's seat, the outside mirrors and the steering wheel. ● Push the ignition switch to the ON position and push the memory switch (1 or 2) fully for at least 1 second. 3-26 Pre-driving checks and adjustments