2009 Infiniti EX35 Owner's Manual - Page 323

b) Push and hold the SET/COAST switch. Release the switch when the vehicle slows down to the desired speed. c) Push, then quickly release the SET/COAST switch. Each time you do this, the set speed will decrease by about 1 MPH (1.6 km/h). To resume the preset speed, push and release the RESUME/ACCELERATE switch. The vehicle will resume the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h). If it is not possible to set or the indicator stays on, it may indicate that the system is malfunctioning. Although the vehicle is still driveable under normal conditions, have the vehicle checked at an INFINITI dealer. PREVIEW FUNCTION (for Intelligent Cruise Control system equipped models) The ICC system with the preview function identifies the need to apply emergency braking by sensing the vehicle ahead in the same lane and the distance to the vehicle ahead and relative speed from it, it applies the brake pre-pressure before the driver depresses the brake pedal and helps improve brake response by reducing pedal free play. For more details, see "BRAKE ASSIST" later in this section. Automatic cancellation Under the following condition, a chime will sound and the system control is automatically canceled. ● When the vehicle slows down more than 8 MPH (13 km/h) below the set speed ● When the vehicle speed falls below approximately 20 MPH (32 km/h) ● When the selector lever is not in the D, DS or Manual mode ● When the parking brake is applied ● When the VDC (including the traction control system) operates ● When a wheel slips SSD0621 Warning light When the system is not operating properly, the chime sounds and the system warning light (orange) will come on. Action to take : If the warning light comes on, park the vehicle in a safe place. Turn the engine off, restart the engine, resume driving and then perform the setting again. Starting and driving 5-45