2013 Jeep Patriot Owner's Manual - Page 176

174 UNDERSTANDING THE FEATURES OF YOUR VEHICLE WARNING! (Continued) set the system or cause it to go faster than you want. You could lose control and have an accident. Always leave the system OFF when you are not using it. To Set A Desired Speed erasing the set speed memory. Pressing the ON/OFF button or turning the ignition switch OFF erases the set speed memory. To Resume Speed To resume a previously set speed, push the RES (+) button and release. Resume can be used at any speed Turn the Electronic Speed Control ON. When the vehicle above 20 mph (32 km/h). has reached the desired speed, press the SET (-) button To Vary The Speed Setting and release. Release the accelerator and the vehicle will When the Electronic Speed Control is set, you can inoperate at the selected speed. crease speed by pushing the RES (+) button. If the button NOTE: The vehicle should be traveling at a steady speed is continually pressed, the set speed will continue to and on level ground before pressing the SET (-) button. increase until the button is released, then the new set speed will be established. To Deactivate A soft tap on the brake pedal, pushing the CANCEL Pressing the RES (+) button once will result in a 1 mph button, or normal brake pressure while slowing the (1.6 km/h) increase in set speed. Each subsequent tap of vehicle will deactivate Electronic Speed Control without the button results in an increase of 1 mph (1.6 km/h).