2013 Jeep Patriot Owner's Manual - Page 183

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 181 5. Press and hold the programmed HomeLink௡ button and observe the indicator light. • If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink௡ button is pressed. • To program the remaining two HomeLink௡ buttons, repeat each step for each remaining button. DO NOT erase the channels. Reprogramming A Single HomeLink௡ Button 3. Without releasing the button proceed with "Programming A Non-Rolling Code" Step 2 and follow all remaining steps. Canadian/Gate Operator Programming For programming transmitters in Canada/United States that require the transmitter signals to "time-out" after several seconds of transmission. 3 Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transTo reprogram a channel that has been previously trained, mission - which may not be long enough for HomeLink௡ follow these steps: to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to 1. Cycle the ignition to the ON/RUN position. time-out in the same manner. 2. Press and hold the desired HomeLink௡ button until It may be helpful to unplug the device during the cycling the indicator light begins to flash after 20 seconds. Do process to prevent possible overheating of the garage not release the button. door or gate motor. 1. Cycle the ignition to the ON/RUN position.