2012 Kawasaki Brute Force 750 4x4i EPS Owners Manual - Page 55

GENERAL INFORMATION 53 Left Handlebar Switches Light/Dimmer Switch: The switch positions are identified on the housing. Headlight and taillight goes on by turning the switch to "LO" (low beam) or "HI" (high beam) with the ignition key in the "ON" position. Select high or low beam as necessary. to operate. If some emergency requires stopping " the engine, shift the engine stop switch to the " position. Although the engine stop switch stops the engine, it does not turn off all the electrical circuits. If the engine stop switch is used, be sure to turn off the ignition switch after stopping the vehicle. Reverse Power Assist Switch (Override): This vehicle is equipped with a reduced reverse speed system. If additional power is needed while backing up, depress the reverse power assist switch. When the switch is released, the vehicle's speed and power return to the reduced mode. j WARNING HAZARD Going too fast in "R" (Reverse). WHAT CAN HAPPEN Going too fast in "R" (Reverse) can cause a loss of control and accident resulting in severe personal injury or death. A. Light/Dimmer Switch B. Engine Stop Switch C. Reverse Power Assist Switch (OVERRIDE) D. Starter Button HOW TO AVOID THE HAZARD Always maintain safe speeds. Use the Reverse Power Assist Switch only if additional power is needed. Starter Button: Refer to the "Starting the Engine" section of the "How to Ride" chapter for starting instructions. Engine Stop Switch: In addition to the ignition switch, the engine stop " position for the engine switch must be in the "