2005 Lincoln Aviator Owner Guide 3rd Printing (Spanish) - Page 528

Lights 2. Carefully pull the bulb straight out of the socket and push in the new bulb. 3. Install the bulb socket in the lamp assembly by turning it counterclockwise. To re-install the headlamp on the vehicle: 1. Install the headlamp on the vehicle by aligning the four plastic projections into the four holes, pushing rearward to seat the lamp assembly. 2. Insert the two retainers, making sure that the retainers go over both plastic projections on each side of the lamp, pushing the retainers down until they seat. 3. Replace the plastic radiator cover by inserting the edge of the cover into the tongue and groove of the mating cover, and then rotating the cover downward. Press firmly on the cover over each headlamp and in the center of the cover to re-engage the snap-in fasteners. 4. Turn the headlamps on and make sure they work properly. Replacing tail/brake/turn/sidemarker/backup lamp bulbs The tail/brake/turn/sidemarker/backup bulbs are located in the tail lamp assembly, one just below the other. Follow the same steps to replace each bulb: 1. Make sure the headlamp switch is in the OFF position and then open the liftgate to expose the lamp assemblies. 2. Remove the two screws from the lamp assembly. 3. Pull the lamp assembly towards the rear and side of the vehicle at an angle, carefully removing it from the vehicle. 4. Rotate the bulb socket counterclockwise and remove from lamp assembly. 5. Pull the bulb straight out of the socket and push in the new bulb. 6. To complete installation, follow the removal procedure in reverse order. 116 2005 Aviator (231) Owners Guide (post-2002-fmt) USA (fus)