2006 Mercedes CL-Class Owner's Manual - Page 60

Getting started Parking and locking Turning off with the SmartKey Turn the SmartKey in the starter switch ( page 34) to position 0 and remove it. The immobilizer is activated. Turning off the engine with KEYLESS-GO* Place the gear selector lever in position P. Press the KEYLESS-GO start/stop button ( page 35) to shut off the engine. With the driver's door closed, the starter switch is now in position 1. With the driver's door opened, the starter switch is set to position 0, same as SmartKey removed from starter switch ( page 34). Releasing seat belts Press the seat belt release button ( page 47). Allow the retractor to completely rewind the seat belt by guiding the latch plate. i The SmartKey can only be removed from the starter switch with the gear selector lever in position P. ! Make sure the seat belt retracts fully so that the seat belt and/or latch plate cannot get caught or pinched in the door or in the seat mechanism. This can damage the seat belt and impair the effectiveness of the seat belt, and/or cause damage to the door and/or door trim panel. Such damage is not covered by the Mercedes-Benz Limited Warranty. Damaged seat belts must be replaced. Contact an authorized Mercedes-Benz Center. i With the SmartKey removed and the driver's door open, a warning sounds if the vehicle's exterior lamps are not switched off. i If you hear a warning signal, you have either forgotten to turn off the lights before opening the driver's door or tried to turn off the engine while the gear selector lever is not in P. Turn off the lights or place the gear selector lever in P. 59