2007 Mercedes CL-Class Owner's Manual - Page 161

Control systems COMAND navigation (introduction) Adjusting: Select "Navi" "Map Display". "Navi" Exiting menu: Slide omp or press back button L in the center console ( page 82). Geo-coordinate display Display options with geo-coordinate display switched on If the crosshair is displayed on the map view (map was moved manually), only display 3 is visible. It shows either the coordinates of the crosshair or other data on the crosshair position, e.g. a street name. The digital map must contain relevant data in order for this other data to be displayed. The map display list appears. A dot R indicates the current setting. Select "Standard symbols", "Personal symbols" or "No symbols". If you select "Personal symbols", the list of POIs appears. Switching POI symbol display on or off: Select the desired POI. The corresponding symbol displays are switched on or off, depending on the previous status. A checkmark indicates which status is active. You can switch on the symbol displays for more than one POI. Illustration: map with geo-coordinate display switched on i If there is no crosshair on the map view, displays 1, 2 and 3 are visible. Display 3 shows the coordinates of the current vehicle position. 1 Current height above sea level 2 Number of GPS satellites from which signals for positioning can be received 3 Coordinate display i The list shows all symbols that are contained in the digital map across all states (USA) and/or provinces (CDN). Not all POIs in all states (USA) or in all provinces (CDN) are available, however. Certain POI symbols may not be displayed on the map, even if the symbol display is switched on. i There must be sufficient GPS reception for displays 1, 2 and 3 to be shown. Height display 1 is an approximation because the navigation system uses the GPS signals for the calculation. 160