2007 Mercedes CL-Class Owner's Manual - Page 186

Control systems COMAND navigation system (entering a destination) Moving the map and selecting the destination Moving map: Slide qmr, omp or wmx. Adjusting map scale: Rotate ymz. Rotating clockwise enlarges the map, rotating counterclockwise reduces it. Selecting a destination: Press n. If the crosshair is located off the edge of the digital map, a route cannot be calculated to this destination and you will see the message "The destination is located off the map.". Select "OK". Move the map and select a destination again. If the destination is within the limits of the digital map, COMAND attempts to attribute the destination to the map, which can take approximately 2 seconds. If the destination can be attributed, you will see the address of the destination. If not, you will see the display "Destination from map". Starting route calculation: Select "Start", see also ( page 181). Entering a stopover i When route guidance is active, you can enter a stopover. Stopovers can be predefined destinations from the following predefined categories: "Mercedes-Benz Center" "Hospital" "Gas station" "Parking lot" "Restaurant" However, you can also enter destinations other than the predefined ones. i You can use the stopover function to influence the route guidance calculation to the main destination. When you have reached your stopover, COMAND automatically calculates the route to the main destination. 185