2007 Mercedes CL-Class Owner's Manual - Page 654
2007 Mercedes CL-Class Manual
Page 654 highlights
Practical hints Flat tire 1 Wheel wrench Take wheel wrench 1 out of the vehicle tool kit tray. On wheel to be changed, lossen but do not yet remove the wheel bolts (approximately one full turn with wheel wrench 1). The jack take-up brackets are located directly behind the front wheel housings and in front of the rear wheel housings. 2 Jack take-up bracket 3 Jack 4 Crank Place jack 3 on firm ground. Position jack 3 under take-up bracket 2 so that it is always vertical (plumb-line) as seen from the side, even if the vehicle is parked on an incline. Jack up the vehicle until the wheel is a maximum of 1.2 in (3 cm) from the ground. Never start engine while vehicle is raised. Warning! G Position the jack only on the jack take-up brackets designed for this purpose. If the jack is not properly positioned, the vehicle may slip off of the jack. 651