2007 Mercedes CL-Class Owner's Manual - Page 442

Controls in detail Driving systems there is a sudden change in temperature, for example when you drive out of the cold into a heated garage in winter (lens condensation) the camera lens is dirty or covered, see "Cleaning the Dynamic Rear View Monitor lens*" ( page 560) the rear of your vehicle is damaged. In this case, have the position and setting of the camera checked by a qualified technician. Contact an authorized Mercedes-Benz Center. Do not use the Dynamic Rear View Monitor if the roads are icy, slippery or covered with snow. The vehicle could slip causing the actual vehicle position to deviate from the one shown on the COMAND display. This may cause injury to you or others, or damage the vehicle or objects. Mounting tires/rims of other specification than the original equipment tires/rims may impair the function of the Dynamic Rear View Monitor. Contact an authorized Mercedes-Benz Center. Warning! G i If you activate a different function on the driver's COMAND controls while reverse parking or parallel parking, the image from the back-up camera is interrupted. To reactivate the camera, take the vehicle out of reverse gear and then re-engage reverse gear again. Use of Dynamic Rear View Monitor can be dangerous if you are color-blind or have impaired color vision. Only use Dynamic Rear View Monitor if you can see and distinguish all colored guide lines shown by Dynamic Rear View Monitor on the COMAND display. Reverse parking (back-in parking) Switching on Dynamic Rear View Monitor i The Dynamic Rear View Monitor must be activated in the instrument cluster control system in order for it to be switched on ( page 269). Switch on the ignition ( page 336). Switch on COMAND ( page 81). Move gear selector lever to position R (reverse gear). The COMAND display will show the area behind the vehicle with guide lines to help you reverse into a parking place. This function helps you when you are reversing in a straight line or backing in at any angle. The space required by the vehicle for reversing is shown by guide lines. When you turn the steering wheel to a straight-ahead position, you will see the guide lines on the COMAND display in the following order: 441