2011 Mercedes S-Class Owner's Manual - Page 161
2011 Mercedes S-Class Manual
Page 161 highlights
Navigation Entering predefined destinations X To switch on navigation mode: press the S function button once or twice. X X X 159 Select the intermediate stop by turning cVd the COMAND controller and press W to confirm. To start route calculation: select Start and press W to confirm. To show the menu: press the COMAND controller W. Select Destination in the navigation system menu bar by turning cVd the COMAND controller and press W to confirm. Select Stopover and press W to confirm. X Entering another destination as an intermediate stop X To switch on navigation mode: press the S function button once or twice. X X X X Select a category, see option 2. Option 2: an intermediate stop has already been entered. X X Select Destination in the navigation system menu bar by turning cVd the COMAND controller and press W to confirm. Select Stopover and press W to confirm. Select Other and press W to confirm. Select Address Entry, From Memory, From Last Destinations or From POIs. Step X Select Change Stopover and press W to confirm. To select a category: select a category by turning cVd the COMAND controller and press W to confirm. COMAND first searches in the selected category for destinations along the route. If there are no destinations available there, COMAND searches for destinations within a radius of up to 100 km (approx. 60 mi) of the vehicle position. If COMAND finds destinations, a list appears on the right-hand side of the display. The intermediate stops are listed according to increasing distance from the current vehicle position. They are displayed in the form of a name and their position in relation to the route and your direction of travel. X X X Selection Address Entry Enter a destination by address (Y page 151). Select a destination from the destination memory (Y page 156). Select a destination from the list of last destinations (Y page 157). Enter a point of interest (Y page 160). From Memory X From Last Destinations X i For intermediate stops that are not located along the calculated route, the linear distance is shown. If COMAND does not find any destinations, you will see a message to this effect. X X From POIs X Confirm OK by pressing W. Select a different category. Z COMAND Option 1: no intermediate stop has been entered yet. To show the menu: press the COMAND controller W.