2010 Mercury Milan Owner's Manual - Page 67

Lights effective point to grasp the trunk side panel when pulling it out from the luggage scuff plate is at it's bottom edge where that edge meets the exposed sheet metal of the trunk floor. Note: Do not allow the trunk side panel to remain bent and untucked from the luggage scuff plate (hard molding) for a long period of time. Doing so may result in permanent deformation. 4. Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly. 5. Pull the bulb from the socket and push in the new bulb. 6. Install the bulb socket into the lamp assembly by rotating it clockwise. 7. Carefully push the trunk side panel (dark grey, soft wheelhouse side trim panel) back to the shingle position to the luggage scuff plate (hard molding). 8. Install trunk floor carpeting panel. Replacing backup lamp bulbs The backup lamp bulbs are located in the trunk lid. 1. Make sure the headlamp switch is in the off position and open trunk to access the lamp assembly. 2. Position the decklid trim aside by removing 3 to 4 pin-type retainers to expose the lamp assembly. 3. Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly. 4. Pull the bulb from the socket and push in the new bulb. 5. Install the bulb socket into the lamp assembly by rotating it clockwise. 6. Carefully reposition the trim back to its original position and secure the retainers. 67