2010 Mercury Milan Owner's Manual - Page 68

Lights Replacing high-mount brake lamp bulb 1. Make sure the ignition control is in the off position. 2. Open the trunk and reach underneath the package tray to locate the lamp assembly. 3. Remove the bulb socket by rotating it counterclockwise, then pull it out of the lamp assembly. 4. Pull the bulb straight from the socket and push in the new bulb. 5. Install the bulb socket into the lamp assembly by rotating it clockwise. Replacing license plate lamp bulbs 1. Make sure the headlamp switch is in the off position. 2. Remove the screws from the license plate lamp assembly. 3. Remove bulb socket by turning counterclockwise. 4. Carefully pull the bulb out from the socket. Install new bulb(s) in reverse order. Replacing fog lamp bulbs 1. Make sure the fog lamp switch is in the off position. 2. From underneath the vehicle, partially remove the tire splash shield by removing four drive screws. After removing to allow free access to the front fog lamp bulb and electrical wire harness, the splash shield flap can be repositioned. 68