2009 Nissan Quest Owner's Manual - Page 161

2. While the indicator light for the memory switch being set is illuminated for 5 secbutton on the keyfob. onds, press the The indicator light will blink. After the indicator light goes off, the keyfob is linked to that memory setting. With the key removed from the ignition switch, button on the keyfob. The drivpress the er's seat, accelerator and brake pedals, and outside mirrors will move to the memorized position. NOTE: If a new memory position is saved to the memory switch, the keyfob automatically re-links. ● If the battery cable is disconnected, or if the fuse opens, the memory storage function will be canceled and must be restarted before a stored memory position can be set again. Drive the vehicle over 25 MPH (40 km/h) to restart the memory storage function. You can also restart the memory storage function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than two times with the ignition switch in the LOCK position. Once the memory storage function has been restarted, you can store a memory position. See "Memory storage function" earlier in this section. The driver's seat, accelerator and brake pedals, and outside mirrors will move to the memorized position with the indicator light blinking, and then the light will stay on for approximately 5 seconds. ENTRY/EXIT FUNCTION This system is designed so that the driver's seat will automatically move when the shift selector is in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward: ● When the key is removed from the ignition switch and the driver's door is opened. ● When the driver's door is opened with the key turned to LOCK. ● When the key is turned from ACC to LOCK with the driver's door open. The driver's seat will return to previous position: ● When the key is inserted into the ignition switch and the driver's door is closed. ● When the driver's door is closed with the key turned to LOCK. ● When the key is turned from ACC to ON while the shift selector is in the P (Park) position. Confirming memory storage ● Turn the ignition switch ON and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. Selecting the memorized position Set the shift selector to the P (Park) position, then: ● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) or ● Turn the ignition switch to the ON position and push the memory switch (1 or 2). Pre-driving checks and adjustments 3-27