2009 Nissan Quest Owner's Manual - Page 244

- Your cellular phone is locked to prevent it from being dialed. ● When the radio wave condition is not ideal or ambient sound is too loud, it may be difficult to hear the other person's voice during a call. ● Do not place the cellular phone in an area surrounded by metal or far away from the in-vehicle phone module to prevent tone quality degradation and wireless connection disruption. ● While a cellular phone is connected through the Bluetooth wireless connection, the battery power of the cellular phone may discharge quicker than usual. The Bluetooth Hands-Free Phone System cannot charge cellular phones. ● If the hands-free phone system seems to be malfunctioning, see "Troubleshooting guide" later in this section. You can also visit www.nissanusa.com/bluetooth for troubleshooting help. ● Some cellular phones or other devices may cause interference or a buzzing noise to come from the audio system speakers. Storing the device in a different location may reduce or eliminate the noise. ● Refer to the cellular phone Owner's Manual regarding the telephone charges, cellular phone antenna and body, etc. USING THE SYSTEM The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. ● Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing voice commands correctly. ● Wait until the tone sounds before speaking a command. Otherwise, the command will not be received properly. ● Start speaking a command within 5 seconds after the tone sounds. ● Speak in a natural voice without pausing between words. Initialization When the ignition switch is placed in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the amber light on the overhead console illuminates and the system is ready to accept voice button is pressed before commands. If the the initialization completes, the system will announce "Hands-free phone system not ready" and will not react to voice commands. Giving voice commands To operate NISSAN Voice Recognition, press and release the button located on the steering wheel. After the tone sounds, speak a command. The command given is picked up by the microphone, and voice feedback is given when the command is accepted. ● If you need to hear the available commands for the current menu again, say "Help" and the system will repeat them. Operating tips To get the best performance out of the NISSAN Voice Recognition system, observe the following: 4-80 Display screen, heater, air conditioner, audio and phone systems