2011 Nissan Versa Owner's Manual - Page 180
2011 Nissan Versa Manual
Page 180 highlights
FM/AM/SAT radio operation FM/AM/SAT band select: Pressing the RADIO button will change the band as follows: AM ←→ FM ←→ SAT (satellite, if so equipped) When the RADIO button is pressed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. No satellite radio reception is available when the RADIO button is pressed to access satellite radio stations unless optional satellite receiver and antenna are installed and an XM satellite radio service subscription is active. Satellite radio can only be installed in vehicles that were factory pre-wired for satellite radio. Satellite radio is not available in Alaska, Hawaii and Guam. If satellite radio is not operational then the RADIO button is used to toggle between AM and FM bands. If a compact disc is playing when the RADIO button is pressed, the compact disc will automatically be turned off and the last radio station played will come on. The FM stereo indicator ST will glow during FM stereo reception. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. To manually TUNE/FF·REW/FOLDER (Tuning): tune the radio, press or the . PRESET A·B·C (Station memory operations): 18 stations can be set for the FM, AM and SAT (satellite, if so equipped) radio to the A, B and C preset button in any combination of FM, AM or SAT stations. 1. Choose preset bank A, B or C using the PRESET A·B·C select button. 2. Select the desired FM, AM or SAT station band. 3. Tune to the desired station using manual, SEEK or SCAN tuning. Press and hold any of the desired station memory buttons (1 - 6) until a beep sound is heard. 4. The channel indicator will then come on and the sound will resume. Programming is now complete. 5. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse opens, the radio memory will be canceled. In that case, reset the desired stations. TUNE/FF·REW/FOLDER button To move quickly through the channels, hold either or button down for more than the 1.5 seconds. SEEK/TRACK/FILE tuning: Press the SEEK/TRACK/FILE button or for less than 1.5 seconds to tune from high to low or low to high frequencies and stop at the next broadcasting station. To seek quickly through the channels, press and hold the SEEK/TRACK/FILE button for more than 1.5 seconds. When the button is released, the radio will seek to the next broadcasting station. SCAN tuning: Press the SCAN button for more than 1.5 seconds to stop at each broadcasting station for 5 seconds. Pressing the button again during this 5 second period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN button is not pressed within 5 seconds, SCAN tuning moves to the next station. Display screen, heater, air conditioner, audio and phone systems 4-33