2011 Nissan Versa Owner's Manual - Page 239

(Drive), the Overdrive off mode will be automatically turned off. WARNING When the high fluid temperature protection mode or fail-safe operation occurs, vehicle speed may be gradually reduced. The reduced speed may be lower than other traffic, which could increase the chance of a collision. Be especially careful when driving. If necessary, pull to the side of the road at a safe place and allow the transmission to return to normal operation, or have it repaired if necessary. CAUTION ● Do not rest your foot on the clutch pedal while driving. This may cause clutch damage. ● Fully depress the clutch pedal before shifting to help prevent transmission damage. ● Stop your vehicle completely before shifting into R (Reverse). ● When the vehicle is stopped with the engine running (for example, at a stop light), shift to N (Neutral) and release the clutch pedal with the foot brake applied. Accelerator downshift - in D position - For passing or hill climbing, depress the accelerator pedal to the floor. This shifts the transmission down into a lower gear, depending on the vehicle speed. Fail-safe When the fail-safe operation occurs, the CVT will not be shifted into the selected driving position. If the vehicle is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail-safe system may be activated. The MIL may come on to indicate the fail-safe mode is activated, see "Malfunction Indicator Light (MIL)" in the "Instruments and controls" section. This will occur even if all electrical circuits are functioning properly. In this case, place the ignition switch in the OFF position and wait for 10 seconds. Then place the ignition switch back in the ON position. The vehicle should return to its normal operating condition. If it does not return to its normal operating condition, have a NISSAN dealer check the transmission and repair if necessary. MANUAL TRANSMISSION (if so equipped) WARNING ● Do not downshift abruptly on slippery roads. This may cause a loss of control. ● Do not over-rev the engine when shifting to a lower gear. This may cause a loss of control or engine damage. 5-22 Starting and driving