2011 Nissan Versa Owner's Manual - Page 184

11. 12. 13. 14. 15. 16. 17. 18. 19. 20. SCAN/RPT button AUDIO button AUX IN jack Station select (1 - 6) buttons VOLUME control knob PWR button iPod MENU button BACK button ENTER button SEEK/TRACK button was playing immediately before the system was turned off. While the system is on, pressing the PWR button turns the system off. Turn the VOL control knob to adjust the volume. MUTE button: Press the button to mute the audio sound. is displayed. This will enable or disable the beep sound heard during menu selection. To change the Speed Sensitive Volume (SSV) mode to OFF, LOW, MID or HIGH, press the or TUNE button setting is displayed. until the desired Press the button again to resume playing the audio at its previous volume. AUDIO button (Bass, Treble, Fade, Balance, SSV, Beep): Press the AUDIO button to change the mode as follows: Bass → Treble → Fade → Balance → Speed Sensitive Volume (SSV) → Beep ON/OFF → Normal mode To adjust Bass, Treble, Fade and Balance, press the AUDIO button until the desired mode appears in the display. Press the TUNE or or SEEK or button to adjust the selected mode to the desired level. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To change the Beep to ON or OFF, press the TUNE button up or down until the desired mode FM/AM/SAT RADIO WITH COMPACT DISC (CD) PLAYER (Type A) (if so equipped) For all operation precautions, see Audio operation precautions in this section. No satellite radio reception is available when the AUX button is pressed to access satellite radio stations unless an optional satellite receiver and antenna are installed and an XM satellite radio service subscription is active. Satellite radio is not available in Alaska, Hawaii and Guam. Once you have adjusted the sound quality to the desired level, press the AUDIO button repeatedly until the radio or CD display reappears. If no action is taken, the radio or CD display will automatically reappear after approximately 5 seconds. Clock set If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK-ON mode. Press the MENU button repeatedly until CLK-OFF mode is displayed. Use the TUNE/FF-REW/FOLDER button to enable CLK-ON mode. 1. Press and hold the CLOCK button until the clock display starts to flash. 2. Press or 3. Press button the SEEK/TRACK button to adjust the hours. the or TUNE/FF-REW/FOLDER to adjust the minutes. Audio main operation POWER/VOLUME control: Place the ignition switch in the ACC or ON position. Press the PWR button while the system is off to call up the mode (radio, CD or AUX) that Display screen, heater, air conditioner, audio and phone systems 4-37