2013 Nissan Altima Owner's Manual - Page 115

Auto-reverse function If the control unit detects something caught in the window as it is closing, the window will be immediately lowered. The auto-reverse function can be activated when the window is closed by automatic operation when the ignition switch is placed in the ON position or for a period of time after the ignition switch is placed in the OFF position. Depending on the environment or driving conditions, the auto-reverse function may be activated if an impact or load similar to something being caught in the window occurs. 1. Place the ignition switch in the ON position. 2. Press and hold the driver's window switch down until the window opens completely. 3. Release the switch. 4. Pull and hold the driver's window switch up to the second detent until the window glass has reached the full close position. Continue to hold the window switch in the up position for 5 seconds after the window glass has reached the full close position. (It is necessary for this entire step to be completed with one continuous pull of the window switch.) 5. Release the switch. Initialization is now complete. The automatic operation for the power window switch should now operate. If the automatic operation does not operate properly after performing the above procedure, see a NISSAN dealer for assistance. No initialization is required for all the other window switches. LIC0410 Automatic operation To fully open a window equipped with automatic operation, press the window switch down to the second detent and release it; it need not be held. The window automatically opens all the way. To stop the window, lift the switch up while the window is opening. To fully close a window equipped with automatic operation, pull the switch up to the second detent and release it; it need not be held. To stop the window, press the switch down while the window is closing. WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window. When the automatic operation for the power window switch does not operate If the automatic operation does not operate properly, perform the following procedure to initialize the power window switch. 2-44 Instruments and controls