2015 Nissan Pathfinder Owner's Manual - Page 194

supplemental restraint system" section of this manual, and "Tilt/Telescopic Steering" and "Outside mirrors" in this section. During this step, do not place the ignition switch in any position other than ON. 4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2). The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds after pushing the switch. After the indicator light goes off, the selected positions are stored in the selected memory (1 or 2). A chime will sound if the memory has been stored correctly (if so equipped). If a new memory is stored in the same memory switch, the previous memory will be deleted. 2. While the indicator light for the memory switch being set is illuminated for 5 secbutton on the key fob. onds, press the The indicator light will blink. After the indicator light goes off, the key fob is linked to that memory setting. With the ignition switch placed in the OFF posibutton on the key fob. The tion, press the driver's seat, steering wheel and outside mirrors will move to the memorized position. NOTE: If a new memory position is saved to the memory switch, the key fob automatically re-links. LPD2113 MEMORY STORAGE FUNCTION Two positions for the driver's seat, steering column, and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Set the Continuously Variable Transmission (CVT) shift lever to the P (Park) position. 2. Place the ignition in the ON position. 3. Adjust the driver's seat, steering column, and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, refer to "Seats" in the "Safety-Seats, seat belts and Linking a key fob to a stored memory position Each key fob can be linked to a stored memory position (memory switch 1 or 2) with the following procedure. 1. Follow the steps for storing a memory position. Reverse tilt-down feature (if so equipped) The reverse tilt-down feature will turn the selected outside mirror surface downward to provide better rear visibility close to the vehicle. When the ignition switch is in the ON position, turn the outside mirror control switch to the left or right position. Only one mirror can be selected at a time. Move the shift lever to R (Reverse). The selected mirror will turn downward. Pre-driving checks and adjustments 3-37