2015 Nissan Pathfinder Owner's Manual - Page 196

Selecting the memorized position Set the shift lever to the P (Park) position, then: ● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) or ● Place the ignition switch in the ON position and push the memory switch (1 or 2). The driver's seat, steering column, and outside mirrors will move to the memorized position with the indicator light blinking, and then the light will stay on for approximately 5 seconds. The driver's seat and steering wheel will return to the previous position: ● When the driver's door is closed with the ignition switch placed in the LOCK position. ● When the ignition switch is turned from ACC to ON while the shift lever is in the P (Park) position. The entry/exit function can be adjusted or canceled through the Vehicle Settings in the vehicle information display by performing the following: ● Switch the Exit Seat Slide from ON to OFF. ● Switch the Exit Steering UP from ON to OFF. SETTING MEMORY FUNCTION The position of the following settings can be linked to the Intelligent Key and the memorized settings can be available for each Intelligent Key. ● Climate control system ● Navigation system (if so equipped) ● Audio system To use the memory function, set the climate, navigation and audio systems to the driver's preferred settings. Lock the doors with the Intelligent Key. Each Intelligent Key may be set with the driver's individual preferences. When a new Intelligent Key is used, "Connection with the key has been done" will be displayed on the screen and the memorized settings are available. To engage the memorized settings, perform the following: 1. Carry the Intelligent Key that is linked to the memorized settings. 2. Unlock the doors by pushing the driver's door handle request switch or the button on the Intelligent UNLOCK Key. 3. Place the ignition switch in the "ON" position. The settings linked to the Intelligent Key will start. ENTRY/EXIT FUNCTION This system is designed so that the driver's seat and automatic operation steering column will automatically move when the shift lever is in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward and the steering column will move up: ● When the driver's door is opened with the ignition switch placed in the LOCK position. ● When the ignition switch is turned from ACC to LOCK with the driver's door open. Restarting the entry/exit function If the battery cable is disconnected or if the fuse opens, the entry/exit function will be disabled. Drive the vehicle over 25 MPH (40 km/h) to restart the entry/exit function. You can also restart the entry/exit function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than two times with the ignition switch in the LOCK position. The entry/exit function should now work properly. Pre-driving checks and adjustments 3-39