2011 Subaru Impreza Owner's Manual - Page 103
2011 Subaru Impreza Manual
Page 103 highlights
2-12 Keys and doors ity reasons. It is recommended that you have your dealer program all of your transmitters into your system. ! Programming the transmitters The remote keyless entry system is equipped with a special code learning feature that allows you to program new transmitter codes into the system or to delete old ones. The system can learn up to four unique transmitter codes. The four transmitter codes may be the same or different. Programming transmitter codes into system: 1) Negative (−) side facing up Transmitter circuit board 3. Replace with a new battery (type CR2025 or equivalent) making sure to install the new battery with the negative (−) side facing up. 4. Refit the removed half of the transmitter case. After the battery is replaced, the transmitter must be synchronized with the remote keyless entry system's control unit. Press either the " " or " " button six times to synchronize the unit. & Replacing lost transmitters If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), you should reprogram all of your transmitters for secur- Bag containing transmitter To register a new transmitter with the remote keyless entry system, it is necessary to program the transmitter's code (identification number) into the system. A label showing the code is affixed to the bag containing the transmitter, and another is affixed to the circuit board inside the transmitter. If there is no bag, open the transmitter case and make a note of the eight-digit number. Program the number into the system in accordance with the following procedure: 1. Firmly close the doors and the rear gate, or trunk lid. 2. Open the driver's door, sit in the driver's seat, and close the door. 3. Perform the following steps within 45 seconds.