3Com 2226 PWR User Guide - Page 34
Changing a Port’s Settings, Configuring Trunk Settings, Table 10
![]() |
UPC - 662705487175
View all 3Com 2226 PWR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
34 CHAPTER 4: CONFIGURING THE SWITCH Changing a Port's Settings If a port is a member of an aggregated link (or trunk), you will not be able to configure its individual port settings. All member ports of an aggregated link will have the same settings, and you can configure these by clicking the AL link on the Port Configuration screen. See "Configuring Trunk Settings" on page 40. To change the settings of a port: 1 Under the Port column of the Port Configuration screen, click the port number that you want to configure. The Port Settings screen appears, as shown in Figure 13. Figure 13 Port Settings Screen Table 10 Port Setting Options Option Description Status ■ Enable - Activates the port ■ Disable - Shuts down or disables the port By default, admin setting is set to enable. Auto Negotiate Autonegotiation, which is enabled by default, sets the optimum combination of speed and duplex that can be supported by both ends of the link. Available options for autonegotiation include: ■ Enable - Enables autonegotiation for the port. If autonegotiation is enabled, options for Speed Duplex are unavailable. ■ Disable - Disables autonegotiation for the port. If autonegotiation is disabled, you need to set the speed and duplex mode in Speed Duplex. 2 Configure the port settings. Available options are listed in Table 10.
![](/manual_guide/products/3com-2226-pwr-user-guide-f8b195d/34.png)